Hitachi SPX-RCK2 Instruction Manual page 12

HOW TO INSTALL WIRELESS REMOTE CONTROL
The remote controller can be placed in its holder which is fixed on wall or beam.
To operate the remote controller at its holder, please ensure that the unit can receive signal transmitted from
the controller at the place where the holder is to be fixed. The unit will beep when signal is received from the
remote controller. The signal transmission is weaken by the fluorescent light. Therefore, during the installation
of the remote control holder, please switch on the light, even during day time, to determine the mounting
location of the holder.
AAA size
battery
Plug
HOW TO EXCHANGE THE BATTERIES IN THE REMOTE CONTROLLER
1
Remove the cover as shown in the figure and take out the
old batteries.
2
Install the new batteries.
The direction of the batteries should match the marks in the
case.
! CAUTION
1. Do not use new and old batteries, or different kinds of batteries
together.
2. Take out the batteries when you do not use the remote controller
for 2 or 3 months.
(EN A5) SPX-RCK2
Black
The controller must be
hooked onto the hook at
the lower part of the
holder. Push in the remote
controller in the direction
as shown in figure below.
=
– 12 –
12
Screw (2 pieces)
Holder for
Remote Controller
Remote
Controller
Push and pull to the
direction of arrow
8/25/08, 12:10