Circuit Breaker - Hitachi SPX-RCK2 Instruction Manual

TEMPORARY SWITCH
Use the temporary switch when operation cannot be done with the
remote controller.
1. By pressing the temporary switch, the operation is done in
previously set operation mode.
When the operation is done using the temporary switch after the
power source is turned off and turned on again, the operation is
done in automatic mode.
2. When the operation is stopped or when the operation is done with
the remote controller again. Press the temporary switch once again.

CIRCUIT BREAKER

When you do not use the room air conditioner, set the circuit breaker to "OFF".
HOW TO INSTALL DISPLAY PANEL
Select an installation position on ceiling or wall where there is no obstacle to interrupt signal reception.
Loosen screws of panel installation plate so that bracket can be slightly moved.
Match the display panel to panel installation plate so the fixing claws on the panel are securely hooked.
Match brackets to the opening on ceiling or wall and tighten screws until bracket is firmly secured to ceiling
material.
Install the panel cover so inside claws are securely hooked to the panel installation plate.
Conduct the indoor unit side housing of display panel cord to the electric box of the indoor unit and connect
it with the housing at the side of the unit.
Attach the connector of display panel to the connector CN11A on the PWB.
(EN A5) SPX-RCK2
Black
– 13 –
13
! CAUTION
Please disconnect wired
remote controller or Weekly
Timer connector at CN1102
if to use wireless remote
controller.
8/25/08, 12:10