The Injection Button Cannot Be Pressed In; The Dose Window Is Not Showing The Number “0” After The Injection - Sanofi-aventis JuniorSTAR User Manual

SHOOTING
2
The needle is blocked or damaged
Solution:
- Dial back the dosage selector to the number "0"
- Replace with a new, full cartridge
- Use a new needle
- Repeat the safety test before injection
The needle has not been attached, or it has not been attached firmly
enough
Solution: Attach the needle properly
No dose has been set
Solution: Set the desired dose by dialing the dosage selector
You might be pressing the injection button at an angle
Solution: Press the injection button straight down into your JuniorSTAR
pen, so that the dosage selector can be turned freely
3
If the dose window shows any number other than "0" after the injection,
the entire dose of insulin has not been injected
Solution: Make sure that you press the injection button until the "0" position is
reached� If this is not possible, you may not have injected your full dose� Do not
try to make up the shortfall by giving a second injection (otherwise you may
be at risk of low blood glucose)� Please check your blood glucose level and
consult your Diabetes Team

The injection button cannot be pressed in

The dose window is not showing the
number "0" after the injection
®
27