Panasonic BB-HGW700A Operating Instructions Manual page 62

Operating Instructions
Data Entry Field
Operation
Entry
No.
Protocol
Forwarding Port
No.
Forwarding IP
Address
Note
When setting up the table, there is a possibility of illegal access to the forwarding port from the Internet.
For safety, only set it when required.
62
Allows you to Modify/Delete the parameters of each heading.
Select Enable or Disable. When Enable is selected, the entry functions as if
set on a table (protocol, forwarding port, forwarding IP address). When
Disable is selected, even if the other headings are set they will not function.
They will function, however, if Enable is re-selected.
Enter the entry number. Entries are processed from the lowest number.
Select a protocol to be used when sending/receiving data over the Internet.
It is possible to select from TCP, UDP, TCP & UDP, ESP, GRE and " ". " "
selects all the protocols.
Specify a port that can be used when sending/receiving data over the
Internet. Specify a forwarding port between 0 and 65535.
• When you only want to use one port, enter that port number.
• When entering a range, enter "-" in between the numbers. For example,
when you want to use port numbers 2000 to 3000, enter "2000-3000".
The number on the left should be lower than the number on the right.
Set the private address for the PC(s) connected to this product. Data from
the Internet will be sent under this IP address. Stabilize this IP address on
compatible PCs.