Error Code Table - Kalorik IKP 40625 Operating Instructions Manual

Fax +1 305 430 9692
445F. When the unit detects a temperature above this limit,
intermittent heating mode will be automatically engaged to avoid a
too high temperature increase and allow for a safe cooking.

ERROR CODE TABLE

Error Cause
code
E0, E2, Internal circuit error –
E5, E6 or parts could be
E7 overheating or have an
open or short circuit
E1 Cookware not detected
E3 Voltage too high
E4 Voltage too low
E7 Overheat protection
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
Suggested solution
Contact Kalorik's Customer Service.
See the „Warranty section" for
details.
1. Check if the cookware has a
magnetic bottom.
2. Ensure the cookware is placed
within the circular placement
guide indicated on the glass
top
3. Cookware was removed
during cooking – replace back
on cooktop.
Have your power supply checked
(it should be 110/120V AC); Unplug
the appliance, wait about 2 min.
and plug in the appliance again
Have your power supply checked
(it should be 110/120V AC); Unplug
the appliance, wait about 2 min.
and plug in the appliance again
1. In "Power" mode: check that
the liquid has not completely
evaporated (Boil dry).
2. If you are not heating liquids,
switch the unit off and then
back on; switch to
"Temperature" mode to
enable a correct temperature
regulation
3. In "Temperature" mode: switch
the unit off, remove the
cookware and leave the
appliance cool down.
10
Assembly page 10/24
special instruction from Team
Print only
IKP 40625 - 141007