Fcc Statement - Lionel Gingerbread Junction Docksider Owner's Manual

Troubleshooting (continued)
Green light begins to flash
Be sure that all the wheels are properly on the track. Ensure that no metal objects are in con-
tact with the track to cause a short. Also, be sure that the power limit of the Transformer has
not been exceeded; the unit will gradually reduce power until the problem is corrected. Note
that the light will also flash when you hold down all three buttons to set the accessory voltage.
Bell button blows whistle
Switch the wire connections at the Transformer terminals. The U terminal should be con-
nected to the outside (common) rail.
Locomotive smoke is light or absent
Be sure that the Smoke Unit switch is in the ON position. Add four to six drops of smoke fluid
if you have not done so already.
We invite you to visit www.lionel.com and click on the Customer Services
tab to order parts and access other important service information.

FCC Statement

Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Notes: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equip-
ment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
19