M-Tronic; Spark Plug - Stihl MS 241 C-M Instruction Manual

English

M-Tronic

Basic information
M-Tronic regulates the fuel quantity and
ignition timing for all operating states
electronically.
M-Tronic stands for easy, fast starting,
constant optimum engine performance,
outstanding acceleration and automatic
adaptation to changes in operating
conditions.
Manual carburetor adjustments are no
longer required – the carburetor does
not have any adjusting screws.
Automatic adjustment
Under extremely changed operating
conditions, attainment of the optimal
setting can be accelerated as follows:
Carry out five uniform cuts to length
N
under full load
36

Spark Plug

If the engine is down on power,
N
difficult to start or runs poorly at idle
speed, first check the spark plug.
Fit a new spark plug after about 100
N
operating hours – or sooner if the
electrodes are badly eroded. Install
only suppressed spark plugs of the
type approved by STIHL – see
"Specifications".
Removing the spark plug
Remove the shroud – see "Shroud"
N
Pull off the spark plug boot
N
Unscrew spark plug
N
Checking the Spark Plug
Clean dirty spark plug.
N
Check electrode gap (A) and
N
readjust if necessary – see
"Specifications".
Rectify the problems which have
N
caused fouling of the spark plug.
Possible causes are:
Too much oil in fuel mix.
–
Dirty air filter.
–
Unfavorable running conditions.
–
WARNING
Arcing may occur if the adapter nut (1) is
loose or missing. Working in an easily
combustible or explosive atmosphere
may cause a fire or an explosion. This
can result result in serious injuries or
damage to property.
A
1
MS 241 C-M