Cleaning The Air Filter; M-Tronic - Stihl MS 201 C-M Instruction Manual

Picco 3/8" P 5.0 mm
Rapid 3/8"; 0.325" 6.0 mm
Rapid 0.404" 7.0 mm
If the groove is not at least this deep:
Replace guide bar
N
Otherwise the drive links will grind
against the base of the groove – the
bottoms of the cutters and the tie straps
will not lie against the bar.
MS 201 C-M

Cleaning the Air Filter

If there is a noticeable loss of engine
power
Turn the twist lock 90°
N
counterclockwise.
Remove the shroud upwards.
N
Remove the air filter upwards.
N
Wash the filter in STIHL special
N
cleaner (special accessory) or a
clean, non-flammable solution (e.g.
warm soapy water) and then dry.
NOTICE
Do not clean a fleece filter (option) with
a brush.
Always replace a damaged filter.

M-Tronic

The chainsaw adjusts itself
automatically for optimum performance
during operation. Calibration enables
the saw to be adjusted faster for
optimum performance.
If the outside temperature is below –
10°C or the engine is cold:
Start the engine and disengage the
N
chain brake.
Warm up the engine by opening and
N
closing the throttle for about 1
minute.
Shut off the engine.
N
Calibrate the chainsaw as follows:
A B
1
min
30-60 s > 30 s
Set Master Control lever to
N
position }.
Engage the chain brake.
N
Start the engine without depressing
N
the throttle trigger. The engine runs
and the Master Control lever
remains in position }.
Run the engine for at least 30
N
seconds but no more than 60
seconds without depressing the
throttle trigger.
English
C
s
31