Stihl MS 362 C-Q Instruction Manual page 7

Before Starting
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
Check operation of chain brake,
–
front hand guard
Correctly mounted guide bar
–
Correctly tensioned chain
–
Smooth action of throttle trigger and
–
throttle trigger lockout – throttle
trigger must return automatically to
idle position.
Master Control lever / stop switch
–
must move easily to STOP or 0
Check that the spark plug boot is
–
secure – a loose boot may cause
arcing that could ignite combustible
fumes and cause a fire.
Never attempt to modify the controls
–
or safety devices in any way.
Keep the handles dry and clean –
–
free from oil and pitch – for safe
control of the chain saw.
To reduce the risk of personal injury, do
not operate your saw if it is damaged or
not properly assembled.
Starting the Engine
Start the engine at least 3 meters from
the fueling spot, outdoors only.
Place the unit on firm ground in an open
area. Make sure you have good balance
and secure footing. Hold the unit
securely. The cutting attachment must
MS 362 C-Q
be clear of the ground and all other
obstructions because it may begin to run
when the engine starts.
Your chain saw is designed to be
operated by one person only. Do not
allow other persons in the work area –
even when starting.
To reduce risk of chain rotation and
personal injury, lock the chain with the
chain brake before starting.
Do not drop start your machine – the
correct starting procedure is described
in the instruction manual.
Do not attempt to start the saw when the
saw chain is in a cut.
Holding and Controlling the Power Tool
Always hold your saw firmly with both
hands: Right hand on the rear handle,
even if you are left-handed. To ensure
safe control, wrap your fingers tightly
around both handles.
During operation
Make sure you always have good
balance and secure footing.
In the event of impending danger or in
an emergency, switch off the engine
immediately by moving the Master
Control lever / stop switch to STOP or 0.
Your power tool is designed to be
operated by one person only. Do not
allow other persons in the work area.
Never leave a running power tool
unattended.
When the engine is running: Note that
the chain continues to rotate for a short
period after you let go of the throttle
trigger (flywheel effect).
Take special care in slippery conditions
– damp, snow, ice, on slopes, uneven
ground and freshly debarked logs.
Watch out for obstacles such as tree
stumps, roots and ditches which could
cause you to trip or stumble.
Do not work alone – keep within calling
distance of others in case help is
needed.
Be particularly alert and cautious when
wearing hearing protection because
your ability to hear warnings (shouts,
alarms, etc.) is restricted.
To reduce the risk of accidents, take a
break in good time to avoid tiredness or
exhaustion.
To reduce risk of fire, keep hot exhaust
gases and hot muffler away from easily
combustible materials (e.g. wood chips,
bark, dry grass, fuel). Mufflers with a
catalytic converter can become
particularly hot.
English
5