Advertisement
Placing the center speaker
Place the speaker on the TV whose top is flat or on the floor
under the TV or inside the TV rack so that it is stabilized.
When placing the speaker on top of the TV, to prevent the
speaker from falling down, put the provided fasteners at two
points on both bottom of the speaker and top of the TV.
Peel off
the seal.
Mounting the surround and surround back speakers on the wall
The speakers can be mounted on a wall by using the
bracket attached to the back panel of each speaker.
Holes
Make sure that the screws are caught by a narrow part of
the holes securely.
Put the screws into a wall according to the figure shown
below.
40 mm
Notes
Fastener
TV set
Fasten screws into a firm wall or wall support as shown in
the figure below, and hang the holes on the protruding
screws.
Pads
WARNING
Do not place the speaker on top of the TV whose
area is smaller than the bottom area of the speaker.
If placed, the speaker may drop out causing an
injury to you.
Do not place the speaker on top of the TV with an
inclination.
Do not touch the adhesive surface after peeling off
the seal as this will weaken its adhesive strength.
Thoroughly wipe clean the surface where the
fastener is to be applied. Note that adhesive
strength is weakened if the surface is dirty, oily or
wet and that this may cause the center speaker to
drop.
3.5 to 4 mm tapping screw
(available at a hardware store)
Wall or
wall
support
Each speaker weights 2.3 kg (5 lbs. 2 oz.). Do not
mount them on thin plywood or soft wall surface
material, as the screws may come out of the flimsy
surface, causing the speakers to fall down and be
damaged, or result in personal injury.
Do not fasten the speakers to wall with nails,
adhesives, or other unsound hardware. Long term
use and vibrations may cause them to fall down.
To avoid accidents resulting from tripping over
loose speaker cords, fix them to the wall.
Screen
3 mm
Min. 20 mm
3
En
Advertisement
