Plasmacluster Unit - Sharp AY-XPC12PU Service Manual

AY-XPC12PU
24) Loose 1 screws of guard holder for wire
guard, and then take off guard holder.
Unhook the wire guard as shown below,
and then take off wire guard.
(Same as left side.)
25) Loosen 3 screws fixing stabilizer R ,
then remove stabilizer R .
26) Cut the fixing band and remove
plasmacluster ass'y.
27) Push 3 hooks, open
plasmacluster ass'y and remove

plasmacluster unit .

Hook
28) Remove horizontal louver, loosen
the screw and remove louver motor .
5 – 6
Hook