Table of Contents
Advertisement
Step 1: Start fixing the rail from the bottom! Do not start installation from the top.
Add the pillar to the rail posts and place the first rail part on the staircase. Fix the post only
temporarily with the worm screws. Do not fix too tight so not to leave pressure marks on
the paint as you might need to change height of the post during installation.
Step 2: In order to later connect both landings stations to the charger it is necessary to
insert a single phase (1x1mm²) cable into the lower tube. If the rail is short this can be
done at the end of the installation. If the rail is long this should be done while combining
the individual rail parts. In this case please enter the cable into the first part and then,
before combining the rail part, also into the second rail part and so forth.
Step 3: Add the second rail part. Now make sure the vertical measures from the first pillars
Y1 and the first pillar of the second rail part Y2 are correct. Check diagonal measure D1
measured from the step nose to the underside of the lower rail. Check also if the angle
indicated in the installation drawing is respected on the installed rail.
Step 4: Make sure all pillars are vertical and also that both rail tubes are aligned vertically
above each other.
ALPHA
stairlift
Stairlift ALPHA Installation Manual
Installation of the rails
Pillar
Connection between first
and second rail part
Edition March 2014
Pillar height
measured from the
center of upper rail
page 3 of 14
Advertisement
Table of Contents
