Seacoast Applications; Oceanside Applications; Required Clearances - LG Multi V ARUN053GF2 Installation Manual

General InstallatIon GuIDelInes
Oceanside Applications / Required Clearances

oceanside applications

Ocean winds may cause corrosion, particularly on the condenser
and evaporator fins, which, in turn could cause product malfunction
or inefficient performance.
• Multi V Space II should be installed in a soundproofed mechanical
room.
• Avoid installing the Space II unit where it would be directly exposed
to ocean winds.
• Install the outdoor unit on the side of the building opposite from
direct ocean winds.
• Select a location with good drainage.
• Periodically clean dust or salt particles off of the heat exchanger
with water.
• If the Space II unit must be placed in a location where it would be
subjected to direct ocean winds, install a concrete windbreaker
strong enough to block any winds.
Additional anti-corrosion treatment may need to be applied to the
outdoor unit at oceanside locations.

required clearances

• Allow adequate clearance for the system louvers
(see figure at right).
• Automatic louver installation = 6 inches
• Manual louver installation = 6 inches
• Fixed louver installation = 4 inches (Basic space)
• Place the product so that the door of the Space II
unit's enclosure can be opened completely for
easier installation and service access.
Water Drain Outlet
• An outlet is required to allow water drainage from
the bottom of the Space II unit enclosure (conden-
sation could form during unit operation).
Figure 3: Water Drain Outlet.
10
Figure 2: Required Clearances for Multi V Space II.
Drain holes
*
Automatic/Manual Louver = 6" Min.
Fixed Louver = 4" Min.
Drain pipe
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Figure 1: Oceanside Placement.
Ocean winds
Ocean winds
Unit = Inches
45 1/2
20
*
*
Door Width
35 1/2