Datalogger DL3 Short manual Mounting Electrical connection Operating controls Manual Thank you for buying this RESOL product. Please read this manual carefully to get the best performance from this unit. Please keep this manual carefully. www.resol.com...
Please pay attention to the following safety advice Proper usage Overview ........... 3 in order to avoid danger and damage to people and Included ............. 4 The RESOL datalogger DL3 is connected to RESOL About this manual........4 property. controllers via the VBus interface. It enables logging ®...
Overview Be it solar thermal, heating or DHW heat exchange controllers – with the RESOL DL3 you can easily and conveniently log system data of up to 6 RESOL controllers. Get a comprehensive overview of all con- trollers connected with the large full graphic display.
Included About this manual This document is a short manual for the DL3 Datalog- ger. This short manual contains information about the following topics: • Installation • Electrical connection • Operating controls • Display screens • Using the SD card...
Wall mounting Upper fastening The unit must only be located in dry interior rooms. It is not suitable for installation in hazardous locations Crosshead and should be protected against electromagnetic screw fields. Please pay attention to separate routing of sensor ca- bles and mains cables.
VBus ® network malfunction! 3 / 4 = VBus ® connection 2 (slave) to the controller (pos. 4) and the DL3 (pos. 1). TION! Separating the device from the 5 / 6 = VBus connection 3 (slave) ® If necessary, extend the cable using the terminal power supply while the VBus®...
VBus device connected with a functioning VBus ® ® During normal operation, the display of the DL3 Da- communication is indicated by a corresponding filled talogger is in the status level (see fig.). checkbox. If no button has been pressed within a couple of min-...
It will not enlarge the hand area of the screen, the temperature value of the The DL3 is equipped with a USB interface to which memory of the DL3 datalogger. corresponding sensor is indicated in °C.
Î Format the SD card using the FAT 32 format iceCenter software. Temperature sensors Î Insert the SD card into the SD card slot of the DL3 The product range includes high-precision platinum 2. Export logged data onto a computer over the The operating control LED starts fl...
Page 12
This mounting- and operation manual including all parts is copyrighted. Another faults can never be excluded, please note: use outside the copyright requires the approval of RESOL – Elektronische Rege- lungen GmbH. This especially applies for copies, translations, micro films and the Your own calculations and plans, under consideration of the current standards and storage into electronic systems.
Need help?
Do you have a question about the DL3 and is the answer not in the manual?
Questions and answers