Kindcomfort KM01 Instructions For Use Manual page 28

5. Pass the seat belt through
and make sure the diagonal belt is passed through
the O guide at the top rear of the seat (4.4, 4.5, 4.6
and 5.7).
6. Insert the vehicle safety belt in the vehicle anchor
point. You will hear a "click" when properly installed
(4.8) .
IMPORTANT
Ensure that the belt has no slack.
5. ADJUSTING CHILD SEAT.
Fastening & Unfastening the harness
1. Join the 2 buckle metal connectors, pass both
connectors through the slot in the upper part of the
buckle until you hear a "click" (5.1).
2. To unfasten the harness press the red button on the
buckle downwards (5.2).
Loosening the harness
3. Release the buckle by sliding the red
downwards and at the same time pulling out the
harness (5.3).
Tightening the harness
4. Pull the harness straps up to remove the slack from
the lap section of the harness, then pull the harness
regulating strap until the harness is fully stretched
(5.4).
5. The harness should be as tight as possible without
causing discomfort to your child.
6. Make sure the lap section of the harness is
positioned as low as possible, surrounding your
child's hips and not his stomach.
28 Child restraint system
R guides behind the seat
F button
KM01