Specifications; Product Identification; Engine; Mower - Jacobsen tournament cut 22 Technical Manual

2

SPECIFICATIONS

2.1 2 SPECIFICATIONS

PRODUCT IDENTIFICATION_________________________________________________

62291............................ 22 in. (559 mm) Tournament Cut
22 with Honda 4.0 H.P. gasoline
engine and 9 blade reel.
Always provide the serial number of the unit when ordering
replacement parts or requesting service information.
TEXTRON TURF CARE AND SPECIALTY PRODUCTS
MADE IN JAPAN, FINAL ASSEMBLY USA
OF U.S. AND IMPORTED PARTS
62291
2.2

ENGINE__________________________________________________________________

Engine.............................. Honda GX-120 K1Q JG2 4-Cycle,
Speed .............................. High Idle - 3000 ± 100 RPM
Fuel .................................. Regular Grade (Unleaded)
Fuel Tank ......................... 0.66 Gallon (2.5 liter)
2.3

MOWER _________________________________________________________________

Reel ................................. 9 blades
Reel Diameter .................. 4 in. (102 mm)
Cutting Width ................... 22 in. (559 mm)
Cutting Frequency/
Fine Finish ....................... 0.199 in. (5.05 mm)
Height of cut..................... 9/64 to 25/64 in. (3.5 to 10 mm)
2.4

TRACTION AND DIFFERENTIAL _____________________________________________

Transport Tires ................ Pneumatic
Reel Drive ........................ Gear Drive
Traction Drive .................. Gear Drive
Traction Reduction Ratio . 21.13:1
Reel Reduction Ratio ....... 1.74:1
Traction Clutch................. Cog type
Drive Clutch ..................... Disc pressure plate type
Travel speed .................... 2.9 mph (4.7 km/h) @ 3000 RPM
Differential........................ Full automotive type, housed in
Rear Drive Drum .............. Corrosion resistant aluminum
6
CHARLOTTE, NC
1601
4HP (2.98 kW) at 4000 RPM
Low Idle - 1700 ± 100 RPM
left gear housing
2 Sections: 6-7/8 (O.D.) x 10.5 in.
(175 x 267 mm)
EEC Sound
Product
Power
62291 100 dba
Use clean, fresh, regular unleaded gasoline, 85 octane
minimum. When using blended fuel, do not use a blend
with more than 10% ethanol.
Under no circumstances should you use a blend with
methanol.
Standard Bedknife:
#2.5............................. Yields 5/32 in. (4 mm) cut
Bedknife Options (See Accesories and Support Literature)
#1.5............................. Yields 7/64 in. (3 mm) cut
#2................................ Yields 9/64 in. (3.5 mm) cut
#3................................ Yields 11/64 in. (4.5 mm) cut
#5................................ Yields 17/64 in. (7 mm) cut
Reel Clutch ...................... Cog Type
2
Vibration M/S
Arms
7