Advertisement
Never cover the heater - there is a risk of fire if covered.
The heater is operated by three switches, located below the canopy.
Switch 1 = O
Switch 2 =
Switch 3 =
The switches are mechanically interlocked, so when switch 1 is turned off, all switches turn off.
Always disconnect the heater from the electricity supply by removing the 3 pin plug and allowing the
heater to cool before undertaking maintenance or replacing lamps.
Lamp Replacement
The lamps fitted to this heater are long life types, but due to the indeterminate life span and ease of replacement are specifically excluded
from the guarantee.
To replace a lamp.
Remove the accessible loose coals. Unhook the front casting by lifting slightly to disengage the unit from the keyhole slots in the trim and
gently pull forward – See figure 6.
Replace with a 60W (maximum) clear Edison screw lamp. Do not use opaque or coloured lamp bulbs.
Refit the front castings and relocate the coals.
Automatic Cut Out
A cut out is fitted to the heating element to prevent damage due to over heating. If it operates due to an obstruction in the airflow, the
heater must be turned off and allowed to cool for 15 minutes with the obstruction removed before restarting.
Care and Cleaning
The canopy trims and glass parts need only to be wiped clean with a dry soft cloth, do not use polishes or abrasive materials.
Fault Finding
No or low light from the fuel effect: Possibly due to a lamp failure. Remove the lamp as detailed above and check it in a table lamp that
is known to work.
No heat or light: Check the wall socket by plugging in a known working appliance. If functional check the 13A fuse in the heater plug. If
either fuse or socket is suspected, have them checked by an electrician.
Light but no heat: The automatic cut out, may have operated, see above.
Disposal
At the end of the products serviceable life it should be disposed of thoughtfully and safely in accordance with local authority regulations.
The plug should be removed from the mains cable. We suggest that you cut the mains cable from the heater to prevent any future unsafe
use of the appliance.
Wickes Helpline
If you require any further assistance please call the Wickes Helpline on 0161 366 4224
To help us quickly help you, please try to have the following information available before you contact us.
•
Your Post Code
•
Type of Fire
•
Model / Name
•
Serial Number
•
The fault, problem or request
OPERATING YOUR HEATER
Main On – Off
In the On position only the fuel effect light operates
1 kW fan heat setting and fuel effect
2 kW fan heat setting and fuel effect
MAINTAINING YOUR FIRE
5 5 5 5
Advertisement
