Download Print this page

Appliance Fixing; Fitting The Front; Final Assembly; Fuel Effects - Wickes 802 Installation And Operating Manual

Advertisement

Appliance Fixing

Method A – Screw Fix
There are two slots in the top flange – See figure 2. Mark the fixing position through the slots.
provided. Reposition the heater body and screw through the slots to provide a secure fixing.
Figure 2
Figure 3
Secondary Screw fixing
If felt beneficial, the appliance can be additionally secured by screws through the side flanges – see
figure 4.
Figure 4
Figure 5
Figure 6

Fuel Effects

Open the polythene bag containing the loose coals and place them on and in front of the coal support to give the most pleasing
effect. It is not necessary to use all the coals supplied.
Place the ash pan into position below the casting.
4 4 4 4
Remove the heater. Drill a hole with a No.12 drill bit at each marked position. Insert the wall plugs
Method B – Wire Fix
The fixing kit includes a steel wire and eyebolt to attach the heater to the back of the fireplace
opening.
Mark the position for the eyebolt at the back of the fireplace opening equal to the centre line of the
heater and at a height of 533 – 560mm. Drill, plug and screw in the eyebolt – See figure 3.
Thread one end of the steel wire through the two holes in the top flange, passing the wire through
the eyebolt and out through one of the opposite holes on the top flange – See figure 3.
Locate the heater into the fireplace opening, then by gently pulling the steel wire, gather up the
excess until the heater is firm.
Thread the wire back through the remaining hole to lock the wire and heater in place –
See figure 3.
If fixing through marble, ensure that both wallplug and screw pass freely through the marble.

Fitting the Front

Carefully lift the front surround. Hook the front surround onto the retaining plates on the heater body
and lower the front surround down – See figure 5.

Final Assembly

Fix the sides of the front surround to the heater body with the two screws provided.
Place the front casting/fuel support in position by passing the screw heads through the key hole
slots in the surround and lowering down – See figure 6.

Advertisement

loading