Table of Contents
Advertisement
INSTALLATION AND OPERATING GUIDE
For
Electric Heaters
Model 801
With
Adorn, Icon, Visage, Elegant or Ultimate Fireslide fronts
&
Model 802
Ultimate, Cosyflame, Fyrside, Nebula & Pizzazz versions
This guide is intended to help you install and care for
your Valor electric heater. Please read carefully before
installing and using your heater.
Important
Please keep your Guide in a safe place for future
reference
600B599/06
Advertisement
Table of Contents
Related Manuals for Valor 802
Summary of Contents for Valor 802
- Page 1 Model 802 Ultimate, Cosyflame, Fyrside, Nebula & Pizzazz versions This guide is intended to help you install and care for your Valor electric heater. Please read carefully before installing and using your heater. Important Please keep your Guide in a safe place for future...
-
Page 2: Customer Care
This guide aims to improve your understanding and appreciation of your new Valor heater, by providing simple and informative instructions to enable you to install it and to ensure that you benefit from the excellent performance and features it has to offer. - Page 3 The following table identifies which spacer or wall kit is available for each heater. The Model 802 Fyreside version is supplied with a 75mm wall kit. For all other appliances the kits are optional extras obtainable either from the your heater supplier or direct from Valor Sales.
-
Page 4: Installation
If the mains cable is damaged, to avoid a hazard it must be replaced by a Valor authorised service agent, or a similarly qualified person. All external wiring between the appliance and the electrical supply, including the earthing, shall comply with current IEE regulations. - Page 5 Method D – With 75mm Wall Spacer Kit (Supplied with Model 802 Fyrside, optional extra with other appliances) The wall kit should be securely fixed to the wall using the screws provided. The heater must then be fixed to the wall kit. (See following section –Wall spacer kit installation) If fixing through marble, ensure that both rawlplug and screw pass freely through the marble.
-
Page 6: Final Assembly
Fix the lower cover to the front surround corner brackets using the two knurled screws provided – See figure 9. Model 801 Visage, Elegant and Ultimate Fireside and all Model 802 versions Place the front casting/fuel support in position by passing the screw heads/hooks through the keyhole slots in the surround and lowering down –... -
Page 7: Operating The Heater
Operating the Heater Never cover the heater, there is a risk of fire if covered. Model 802 The heater is operated by three switches, located below the canopy. Switch 1 = O Main On – Off In the On position only the fuel effect light operates ❙... - Page 8 The Slider Control There are four slider positions Fuel effect lighting on Fan Coolblow on. Fuel effect lighting on (Set thermostat at High). Fan heater on (2kw). Fuel effect lighting on (Set thermostat to a high setting and allow the room temperature to settle before re-adjusting).
-
Page 9: Maintaining Your Fire
Maintaining Your Fire Always disconnect the heater from the electricity supply by removing the 3 pin plug and allowing the heater to cool before undertaking maintenance or replacing lamps. Lamp Replacement The lamps fitted to this heater are long life types, but due to the indeterminate life span and ease of replacement are specifically excluded from the guarantee. -
Page 10: Useful Telephone Numbers
• Serial Number • The fault, problem or request General advice about your heater VALOR ADVICE LINE 08457 626 341 To report faults or arrange for your heater to be serviced VALOR SERVICE 0121 386 6203 To order spares or for sales information...