Advancing The Line; Advancing The Line Manually; Using The Power Saver Feature - Toro 51487AT Operator's Manual

Advancing the Line

The trimmer is equipped with an auto-feed head. The line will
advance 6 mm (1/4 inch) each time you stop and start the
trimmer. When the line reaches the blade in the deflector, it will
be cut off at that length.
1. With the trimmer running, release the switch trigger.
2. Wait 2 seconds, then press the switch trigger.
3. Resume trimming.

Advancing the Line Manually

Disconnect from the power supply, then push the button at the
base of the spool retainer while pulling on the trimmer line to
manually advance the line.
1. Button
Figure 13
Trimming
Edging
To use the trimmer as edger, press the rotator button and rotate
the head as shown in Figure
1
1. Rotator button

Using the Power Saver Feature

Engaging the power saver feature will extend the run time of the
battery by shortening the length of the trimmer line and decreasing
the load on the motor.
If you are experiencing reduced battery runtime, it is recommended
that you engage the power saver feature.
9
Figure 14
15.
2
G015660
Figure 15
2. Edger guide
G016254