Installing The Auxiliary Handle; Installing The Guard - Toro 51487AT Operator's Manual

Installing the Auxiliary Handle

1. Position the auxiliary handle on the shaft of the trimmer with
the smooth surface facing the operator
2
1. Auxiliary handle
2. Latch
2. Slide the brace into the auxiliary handle so that the brace
rests in the groove along the shaft
3. Slide the latch from the left through the handle and brace
as shown, and tighten the latch screw with a Phillips
screwdriver (Figure 4).

Installing the Guard

1. Remove the Phillips screw taped to the guard
2. Slide the guard onto the trimmer base as shown in
G017622
1. Phillips screw
(Figure 4).
1
3
G017277
Figure 4
3. Brace
(Figure 4).
(Figure
Figure 5
2. Guard
3. Secure the guard using a Phillips screw.
Installing the Edge Guard
Insert the ends of the wire edge guard into the holes in the trimmer
housing, as shown in
1. Wire edge guard
5).
Figure 5.
6
Figure 6.
G017621
Figure 6
1