Table of Contents
Advertisement
3. Getting ready to start recording
Getting ready to start recording
3.1 Insert memory card
1) Turn the VDR off / Unplug Power
/ Unplug Power
2) Open the memory card cover as shown in the figure
rd cover as shown in the figure
3) Insert the memory card into the card slot until it
3) Insert the memory card into the card slot until it clicks
* Make sure VDR is placed as shown
is placed as shown below and the terminal portion of the card is facing up
4) Close the cover
3.2 Remove memory card
1) Turn the VDR off / Unplug Power
/ Unplug Power
2) Open the memory card cover as shown in the figure
3) Gently push the memory card to eject
he memory card to eject
4) Pull the memory card out of the memory
Pull the memory card out of the memory card slots and close the cover
After a period of use, the memory card may get warm. This is normal operation and not malfunction
After a period of use, the memory card may get warm. This is normal
• If the memory card is ejected
• To avoid damage and or data loss,
off the vehicle BEFORE inserti
• Do not push the memory card too hard as t
push the memory card too hard as the memory card may pop out
• It is HIGHLY recommended to use
recommended to use new SD card to ensure data integrity
• Turning the power off or removing a memory card during operation such as f
recording and playback may cause data loss
and playback may cause data loss
USER GUIDE V1.0.0
USER GUIDE V1.0.0
USER GUIDE V1.0.0
Inserting and removing SD memory card
Inserting and removing SD memory card
rd cover as shown in the figure
is ejected from the drive recorder while it is on, the VDR will
data loss, power off the system by removing the power cable
inserting or ejecting the SD card
off or removing a memory card during operation such as formatting, deleting,
ortion of the card is facing up
and not malfunction
n, the VDR will shut off
the power cable or turning
ormatting, deleting,
11
Advertisement
Table of Contents
