Garmin APOLLO GX SERIES Service Manual page 163

GX Service Data Sheet (Manual P/N 560-7001-5XX)
NOTE: GX Service Data Sheet procedures provide step by step
instruction for filling out this form.
PRELIMINARY INSPECTION
Technician
RMA#____________________ Serial #
P/N_________________
Mod
VISUAL DAMAGE
Visual Damage Initials: _____________Date: ___________________
____None ___Hardware Damage
Visual Damage Details: _____________________________________
________________________________________________________
________________________________________________________
HIDDEN DAMAGE
Hidden Damage Initials_____________Date____________________
____No Damage Found ___Minor Damage
Hidden Damage Details: ___________________________________
_______________________________________________________
_______________________________________________________
NORMAL MODE NAV INFO
Last Valid Pos: ____________________/___________________
CDI Scaling ____Automatic
Direct-To Entry ____Never Clears ____May Clear
Date & UTC ____Correct
Software Version: NAV________
Database Expiration Date ______ / ______ / ____________
Database Part Number
NORMAL MODE COM INFO(GX60/65)
COM SW V2.X
Intercom SQLCH:______MIC1
_____MIC2
Transmit using: _______MIC1
and MIC2
_____MIC1 only
_____MIC2 only
Intercom Level: ___________________________
Sidetone Level: ___________________________
Headphone Level: _________________________
TEST MODE NAV INFO
Serial Ports: Channel RX
1: ___________
2: ___________
IFR APPROACH
YES ________ ________
NO ________ ________
Date
Model
____Other
____Major Damage
____Manual
Not Correct______________________
GPS_________ COMM________
138-
COM SW V1.X
Intercom SQLCH
Intercom Level______________
Sidetone Level _____________
Headphone Level ___________
TX
____________
____________
SAR
________
________
EEPROM BYTE Info
Address Description
0219 Equipment Run Time
0224 Turn On Cycle Count
0229 EEPROM Failures
0230 NVRAM Failures
0231 Minor Math Errors
0232 Major Math Errors
0233 Exception Interruption
TEST MODE COMM Info (Comm V 2.X only)
RX Squelch Level________________
MIC 1 Level________________
MIC 2 Level________________
FINAL ACCEPTANCE TEST
Technician: __________________ Date: ___________________
______Return to Service Procedures Completed (Chapter 11)
______RS232 Load Test per MET 154
______3D Pos, SNRs, Elev, & AZM Match Standard Unit
______Verify Lat/Long matches the standard unit.
______Verify Time and Date
______Verify Software Versions for:
Nav Application: ________ GPS _______ Display
______Emergency Search (nearest airport)
______Verify Board Rev Stickers
______Bump Test (Raise front of unit 3" and drop it. Observe
display for changes/blinking.)
______Check messages for return to service messages
FINAL INSPECTION
Inspector:________________________ Date: _______________
______Final Acceptance Test Checklist completed above
______Scan area of replaced components
______Backlighting (display and buttons)
______Unit and Board Configuration Correct (See Unit
Configurations)
______Verify UTC Time
______Covers, Rods and Screws Installed
______Verify customer setup with Service Data Sheet
______Replaced cover screws
Data Value
_______________
_______________
_______________
_______________
_______________
_______________
_______________
Page 1 of 2
P/N: 561-6001-50
11/4/04