Adapting Blower For Outside Ventilation; Check For Proper Damper Operation; Mount The Microwave Oven - GE pvm9179 Installation Instructions Manual

A4. ADAPTING BLOWER FOR
OUTSIDE VENTILATION (Cont.)
7
Place the blower unit back into the opening.
CAUTION
Do not pull or stretch the blower
unit wiring. Make sure the wires are not pinched.
8
Close the blower door. Secure the blower to the
microwave using the screws from Step 1.
CHECK FOR PROPER
A5.
DAMPER OPERATION
Blower Plate
Retaining Hooks
• Place the microwave in its upright position, with the
top of the unit facing up.
• Make sure tape securing damper is removed and
damper pivots easily before mounting microwave.
• Slide the damper into place. Make sure it catches
in the retaining hooks to secure.
• You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
microwave is installed.
Installation Instructions
Damper
Exhaust Adaptor
Back of
Microwave
Oven
14
A6.

MOUNT THE MICROWAVE OVEN

CAUTION
FOR EASIER INSTALLATION AND
PERSONAL SAFETY, WE RECOMMEND THAT TWO
PEOPLE INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from
overtightening screws.
NOTE: When mounting the
microwave oven, thread
power cord through hole
in bottom of top cabinet.
Keep it tight throughout
Steps 1–3. Do not pinch
cord or lift oven by pulling
cord.
2 Rotate front of oven up
against cabinet
bottom.
3 Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord tight.
Be careful not to pinch the cord, especially when
mounting flush to bottom of cabinet.
1 Lift microwave, tilt it
forward, and hook slots
at back bottom edge
onto four lower tabs of
mounting plate.