Advertisement
Desktop Installation
To set up the UNITY500 in a desktop environment, place it on a flat surface where it will not be subject to being
hit or pushed, and will not have anything spilled or dropped on it. Also, the cables connected to the unit should
be routed so they are not hit or pulled, which might cause damage to the connectors or to the unit itself.
Additionally, there should be sufficient flow of cool air so the unit stays within its operating parameters.
Rack Installation
When installed in an equipment rack, it is best that the UNITY500 be supported by angle brackets or cross
supports. These should be screwed or bolted securely to the equipment rack, and be capable of supporting the
unit and its connecting cables. Do NOT install the unit if you have doubts about the unit being safely supported.
There are also 4 holes in the front brackets, which are designed to accept screws for further anchoring. It is
also essential that these brackets be used so the unit cannot be moved forward and fall from the rack. It is
always best to install the angle brackets or cross-members before setting the unit in place. Then, prior to
installing cables, put anchored screws or bolts-and-nuts into place on the front brackets. Failure to do this can
lead to pushing the unit out the front of the rack in later steps.
Warranty
The following warranty applies to all Wegener Communications products. All Wegener Communications
products are warranted against defective materials and workmanship for a period of one year after shipment to
customer. Wegener Communications' obligation under this warranty is limited to repairing or, at Wegener
Communications' option, replacing parts, subassemblies, or entire assemblies. Wegener Communications shall
not be liable for any special, indirect, or consequential damages. This warranty does not cover parts or
equipment, which have been subject to misuse, negligence, or accident by the customer during use. All
shipping costs for warranty repairs shall be prepaid by the customer. There are no other warranties, express or
implied, except as stated herein.
Technical Support
In the event the unit fails to perform as described, contact Wegener Communications Customer Service at (770)
814-4057, FAX (678) 624-0294, or E-mail "service@wegener.com".
Corporate Office
Wegener Communications, Inc.
11350 Technology Circle
Duluth, GA 30097
800010 Rev. A – Printed in USA
Service Department
359 Curie Drive
Alpharetta, GA 30005
Page 4 of 4
Advertisement
