Table of Contents
Advertisement
Time programming function
This function may be used in two different ways:
to automatically switch off a hotplate.
■
as a timer.
■
A hotplate should switch off automatically
Enter a cooking time for your food. The hotplate switches off
automatically after the time that is set has elapsed.
Setting procedure
Select the hotplate and the required heat setting.
1.
Touch the
symbol twice.
0
2.
display.
Within the next 10 seconds, set the required cooking time
3.
using the figures 1 to 9.
The cooking time begins to elapse.
Note: The same cooking time can be automatically
programmed for the all the hotplates. The programmed time
passes independently for each of the hotplates.
The Basic settings chapter provides information on
automatically programming the cooking time.
Changing or cancelling the time
Select the hotplate and press the
The __ and
r
displays appear
Change the cooking time using symbols 1 to 9 or press 0 to
cancel the time.
Cleaning lock function
Cleaning the control panel while the hob is on may change the
settings.
In order to avoid this, the hob has a cleaning lock function.
Press the
>D
symbol. A signal sounds. The control panel is
locked for 35 seconds. The surface of the control panel can
now be cleaned without risk of changing the settings.
Automatic time limitation
If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. The
heat indicator
œ
/
•
flash alternatively in the display.
12
and __ light up in the timer
‹‹ y
symbol twice.
0
symbol and the residual
"‰
Once the time has elapsed
The hotplate switches off once this time has elapsed. A beep is
heard and
‹
.
‹
appears in the hotplate and the time
programming function display shows
When the
0
symbol is pressed, the displays turn off and the
beep goes off.
Notes
If a cooking time has been programmed, the display always
■
shows the time of this function. To check the cooking time
remaining in a hotplate, select a hotplate and press the
0
symbol twice.
If a time has been programmed for several hotplates, the
■
time of the selected hotplate is always shown.
Any cooking time can be programmed for up to 99 minutes.
■
The timer
The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
Press the
0
symbol. The indicator
1.
in the time program function display.
Set the required time using symbols 1 to 9.
2.
The time starts again after a few seconds.
Once the time has elapsed
Once the time has elapsed, a beep will sound.
displayed in the time program function display. After pressing
the
symbol, the indications turn off.
0
Changing or cancelling the time
Press the
0
symbol, the
U
Change the time using the 1 to 9 symbols or press 0 to cancel.
Note: The lock does not affect the main switch. The hob may
be switched off when desired.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
for 10 seconds.
‹‹
U
lights up.
‹‹
lights up
and
‹‹
indicator lights up.
are
U
Advertisement
Table of Contents
