Control Settings - GEAppliances GSD5610 Owner's Manual

About the dishwasher control panel.
You can locate your model number on the tub wall just inside the door.
Throughout this manual, features and appearance may vary from your model.
STATUS
SENSING Clean Sensor
WASHING
SANI POTS
RINSING
WASH & PANS
DRYING
SANITIZED
1

Control Settings

1 The Status
The Status display tells you what's happening while the dishwasher is in operation
and also any malfunctions if they occur (see page 10). The lights will come ON
indicating the sequence of operation the dishwasher is in.
SENSING Displayed during periods using CleanSensor technology to measure the amount of soil
in the load and decide if another prewash is needed. The SENSING light is displayed
only during NORMAL and POTS & PANS cycles.
WASHING Displayed during prewash and main wash periods.
RINSING Displayed during rinse periods.
DRYING Displayed during SPEED DRYING .
SANITIZED Displayed when cycle has met sanitization conditions. Light remains ON until door is
opened.
Load Selections
2
The light above the selected pad will be ON to indicate which LOAD SELECTION has been selected.
SANI WASH This cycle raises the water temperature in the final rinse to sanitize your dishware.
The cycle length will vary depending on the temperature of your inlet water.
NOTE: The SaniWash cycle is monitored for sanitization requirements. If the
cycle is interrupted during or after the main wash portion or if the incoming
water temperature is so low that adequate water heating cannot be achieved,
the sanitizing conditions will not be met. In these cases, the sanitized light will
not illuminate at the end of the cycle.
POTS & PANS For heavily soiled dishes or cookware with dried-on or baked-on soils. Everyday
dishes may be included. This cycle will not remove burned-on foods.
NORMAL For loads of everyday dishes and glassware with medium soils.
CHINA CRYSTAL For lightly soiled china and crystal.
SPEED WASH For lightly soiled dishes and glassware.
RINSE ONLY For rinsing partial loads that will be washed later. Do not use detergent with
this cycle.
8
LOAD SELECTIONS
CHINA SPEED RINSE POWER
NORMAL
CRYSTAL WASH ONLY PRESOAK
2
OPTIONS
CLEAN
2 4 8
START
SPEED LOCK DELAY
(2 TIMES)
DRY START RESET
3 4
5