Advertisement
Installation manual
Connect the meter in accordance with the installation diagram on the meter's type label.
Depending on the configuration a fixed value will be displayed, or the display will change
between selected indications every 10 seconds.
It is possible to change the display reading manually by activating the push button on the
meter. The available readings will depend on the meter's configuration.
Security and installation guidelines
The meter is only to be used for measuring electrical energy and shall operate within the
specified values only.
The meter must be disconnected when working on it. It can be highly dangerous to touch the
meter parts when the meter is switched on.
Therefore, the relevant security fuse must be removed and kept in a place where it cannot be
inserted by unauthorized persons.
Current local standards, guidelines, regulations and instruction must be observed. Only
authorized personnel is permitted to install electricity meters.
Meters for direct connection must be protected against short circuit by a security fuse in
accordance with the maximum current stated on the meter.
Secondary module
Optical interface
LED (meter constant)
LED breaker status
(only meters with
internal breaker)
The meter constant LED blinks proportionally to the consumed active energy.
Only authorized personnel must break the utility sealing.
LCD-display
Push button
Push button
(not used)
Type label
Utility seals
2
55121131_B1_GB_10.2013
Advertisement
