Independent Installation Of Z-Type Clamp Single Module - GH Solar GHxxxP-36 Series Installation Manual

Note:
 Clearance between modules frames and surface of the wall or roof is required
to prevent wiring damage and to allow air to circulate behind the module.
Recommended stand-off height is 115mm.
 When mounting, be sure that the module's drain holes are not blocked.
 Please use corrosion-proof screws (M8) in the existing installing holes in the
module frame.
 We recommend that the longer size of the frame should be stick to the
bracket completely. For safety, the bracket width should be wider than the
frame face which stick to the bracket. The thickness of the bracket had better
withstand the impact of external 5400pa forces.

3.1.2. Independent installation of Z-type clamp single module

The module clamps should not come into contact with the front glass and must not deform
the frame. Be sure to avoid shadowing effects from the module clamps.
The installation adopts Z-type clamp single module independent installation frame
mechanical load test includes wind load 2400PA and snow 5400PA.
The 2400 Pa test takes the inside installation hole position as benchmark, and fix clamp