Beep Symptoms; No-Beep Symptoms; Lcd-Related Symptoms - Lenovo ThinkPad 13 Hardware Maintenance Manual

Beep symptoms

Table 4. Beep symptoms
Symptom or error
Four cycles of four short beeps
One short beep, pause, three short beeps, pause, three
more short beeps, pause, and one short beep
Five short beeps, pause, five short beeps, and pause

No-beep symptoms

Table 5. No-beep symptoms
Symptom or error
No beep, power-on indicator on, LCD blank, and no
POST.
No beep, power-on indicator on, and LCD blank during
POST.
The power-on password prompt appears.
The hard-disk password prompt appears.

LCD-related symptoms

Important: The TFT LCD for the notebook computer contains many thin-film transistors (TFTs). The
presence of a small number of dots that are missing, discolored, or always lighted is characteristic of TFT
LCD technology, but excessive pixel problems can cause viewing concerns.If the LCD you are servicing has
two or less visible defective pixels, it should not be considered faulty. However, if the LCD has three or more
visible defective pixels, it will be deemed as defective by Lenovo and it should be replaced.
Notes:
• This policy applies to all ThinkPad notebooks purchased on 1 January, 2008 or later.
• Lenovo will not provide warranty replacement if the LCD is within specifications because we cannot
guarantee that any replacement LCD will have zero pixel defects.
• One pixel consists of R, G, B sub-pixels.
Table 6. LCD-related symptoms
Symptom or error
No beep, power-on indicator on, and a blank LCD during
POST.
• LCD backlight not working.
• LCD too dark.
• LCD brightness cannot be adjusted.
• LCD contrast cannot be adjusted.
FRU or action, in sequence
Replace the system board.
1. Replace the memory module.
2. Replace the system board.
Replace the system board.
FRU or action, in sequence
1. Ensure that every connector is connected tightly
and correctly.
2. Reseat memory module.
3. Replace the system board.
1. Reseat memory module.
2. Replace the system board.
A power-on password or a supervisor password is set.
Type the password and press Enter.
A hard disk password is set. Type the password and
press Enter.
FRU or action, in sequence
Replace the system board.
1. Reseat the LCD connectors.
2. Replace the LCD assembly.
3. Replace the system board.
Chapter 4
.
Related service information
37