Advertisement

Owner's Manual
Einstein BarkLess
BL-100

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Einstein BarkLess BL-100 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for E-Collar Einstein BarkLess BL-100

  • Page 1 Owner’s Manual Einstein BarkLess BL-100...
  • Page 2 We assemble all of our products in the USA and are confident that you will be highly satisfied with E-Collar Technologies equipment. Thank you again for choosing E-Collar Technologies and good luck with your training and have a great day. CHARACTERISTICS Incorporates Time Delay Between Stimulation Routines.
  • Page 3: Table Of Contents

    COMPONENTS • BL-��� Collar Unit with Collar Strap • Lithium Polymer Charge Adaptor • Owner’s Manual • Stainless Steel Contact Points TABLE OF CONTENTS • Getting Started .................�� • Charging the Collar Unit ..............�� • Power On/Off ..................�� • Mode Select Dial ................��...
  • Page 4: Getting Started

    GETTING STARTED Contact Points This Buckle Style NOT FOR TIE OUT Battery Charging Receptacle & Rubber Cover Bark Sensor Collar Strap Indicator Light Rough Surface for Test On/Off & Mode Select Dial CHARGING THE COLLAR UNIT Charge Adaptor(�V ����mA) ���~��� Volt Charger �.
  • Page 5: Power On/Off

    POWER ON/OFF To turn on the BL-���, rotate the dial to any position other than OFF. Decrease To turn off the BL-���, rotate the dial to the OFF position as shown in the figure. Increase MODE SELECT DIAL The mode select dial on BL-��� Mode Description is used to turn power on/off and...
  • Page 6: Test Mode

    TEST MODE �. Rotate the mode select dial to “T”. The LED will be ON for � second and will flicker thereafter. After a while, the BL-��� will enter a sleep mode and the LED is turned off. �. If the sensor detects any signal, tone and level � stimulation will be triggered with red LED.
  • Page 7: Changing The Mode

    CHANGING THE MODE Tone Only Mode Rotate the mode select dial to “B”. �. �. When your dog barks, the BL-��� will emit only a tone. Level � Mode Rotate the mode select dial to “�”. �. �. When your dog barks, the BL-��� will emit an education tone and a level �...
  • Page 8: How To Select The Correct Mode

    �. If the dog barks again within �� minutes in this state, the education tone and level � stimulus will be emitted again. If the dog barks again within �� minutes, BL-��� will change the �. stimulation level and emit an education tone followed by a level � stimulus.
  • Page 9: Indicator Light

    INDICATOR LIGHT When turned on, Indicator light will be on for � second and flicker thereafter. If there is no bark sound for a while, Indicator Light the BL-��� will go to sleep mode and LED is off also. Before the BL-��� goes to sleep mode, LED will flicker based on the battery charge level.
  • Page 10: Contact Points

    �� hours per day. Should your dog experience skin irritations from over exposure to the contact points remove the collar receiver unit immediately and stop using your e-collar until all skin irritations are totally healed. Antibiotic ointment will aid in the healing process.
  • Page 11: Warranty And Repair

    All material will be provided at no cost to the customer. Labor fees will be calculated based on the extent of the work performed. We will not be satisfied until you are ���% satisfied with your product from E-Collar Technologies.
  • Page 12 E-Collar Technologies, Inc. 2120 Forrest Park Drive Garrett, IN 46738-1887 1-855-326-5527 (Toll Free) • Ext. 1: Sales • Ext. 2: Customer Service 1-855-226-5527 (Toll Free Fax) customerservice@ecollar.com www.ecollar.com ©2011 E-Collar Technologies, Inc. Thank you for Supporting American Workers...

Table of Contents