Display Set-Up; Location For Installation; How To Install; Power Cable Connection - Samyung SMR-3700 User Manual

5.3. DISPLAY SET-UP

5.3.1. Location for installation

※ A display must be installed far away over than 1 meter from a magnet compass.
※ It may be harmful to the magnet compass in case of closer installation.
 Select the location for easy-investigation and maintenance.

5.3.2 How to Install

(1) Install the display according to the Block Diagram.
(2) Refer to the installation diagram.

5.3.3. Power Cable connection

(1) Connect a Power cable to [POWER] of the back-pannel.
(2) Connect an Aireal-cable to [SCANNER] of the back-pannel.
(3) Connect an earth cable to [EARTH] of the back-pannel.

5.4. Installation check

 After installation, check weather the condition is O.K based on the instruction. The serious
check points are the cable connection, tight connection of each units, aireal-cable, the
connection of cable shield.
 Set the FUSE after measuring the power supply voltage
※ DC12V : USE FUSE 10A, DC24V : USE FUSE 5A

5.5. Operation check

(1) Before the operation check, it needs to check if the internal voltage is in an acceptable
voltage range.
(2) Check all parts of the radar in detail after operation check.
(3) Readjustment should be according to the manual even though the operation check is
O.K.
ATTENTION
44