New Confirmation Message When The Automation Stops Due To Low Memory; New Indication Of The Start Scene In The [Automation>Execute] Window; New Visual Indication Of Locate Points - Panasonic RAMSA WR-DA7 User Manual

Version 2.0: When accessing the [AUTOMATION>EXECUTE] window, the
cursor position now defaults to the TIME BASE area.
15. New confirmation message when the Automation stops due to low
memory.
Previous Versions: No warning was displayed when the Automation stopped
recording because the automation memory was full.
Version 2.0: Now, when the internal memory for Automation is full,
recording will stop and a confirmation message, "NO MEMORY FOR
AUTOMATION RECORDING", will be displayed. If you see this message on a
regular basis, you should consider ways to conserve the internal automation
memory by using different mixing techniques. One method of conserving
memory is to use scene memory recall during automation. For example,
scene 1 could be the start of the verse, scene 2 could be the chorus. Then
instead of making lots of moves to go from the verse to the chorus, simply
recall a scene. Utilizing this method, the savings to the automation memory
is substantial. If this method is not sufficient, you should consider our
optional MAX software automation package.
16. New indication of a new START SCENE in the
[AUTOMATION>EXECUTE] window.
Previous Versions: In the [AUTOMATION>EXECUTE] window, the START
SCENE would flash momentarily when entering a new START SCENE.
Version 2.0: Now when a new START SCENE is written, the TIME CODE
DISPLAY will change to inverse video momentarily. This confirms that the
new START SCENE has been written.

17. New visual indication of LOCATE points.

Previous Versions: Not Implemented (This shortcut was introduced in
Version 1.10.)
Version 2.0: In the [AUTOMATION>EXECUTE] window, pushing a LOCATE
button while in the MMC mode will momentarily display the location points
destination time code in inverse video in the TIME CODE DISPLAY.
2 - 9