New Shortcut To Recall All Scenes Directly From The Ten Key Pad; New Screen Navigation Using Cursor Repeat Functions - Panasonic RAMSA WR-DA7 User Manual

Continued from the previous page
SET UP KEY
(Window Group)
[METER]
[METER]
[METER]
[AUTOMATION]
[AUTOMATION]
[AUTOMATION]

5. New shortcut to recall all SCENES directly from the Ten Key Pad.

Previous Versions: The 50 Scenes in the Scene Memory were only accessible
from within the [SCENE MEMORY RD/WR] window. If the 10 KEY SCENE
RECALL mode was selected to ON in the [UTILITY>CONFIG] window, only
the first 10 scenes could be recalled from the TEN KEY PAD.
Version 2.0: When the 10 KEY SCENE RECALL mode is selected to ON in the
[UTILITY>CONFIG] window, any of the 50 scenes can be selected from the
TEN KEY PAD on the Top Panel of the DA7 by entering 2 digits on the 10 KEY
PAD. You must enter "0" before the scene number to recall scenes 01-09. The
scene is recalled immediately after pressing the last number. Example: If you
wanted to change a scene during automation recording, i.e. going from scene
12 to scene 24, you could get ready to punch the scene in, by selecting the '2'
on the 10 Key Pad, then precisely when you wanted the scene to change,
press the '4', and the scene will change to scene 24. The same applies in live
applications where you will want to manually change from scene to scene
without going to the [SCENE MEMORY>RD/WR] window.

6. New Screen navigation using Cursor Repeat Functions.

Previous Versions: The ARROW keys must be pressed repeatedly to move
the cursor within the LCD screen.
Version 2.0: By holding down any of the cursor ARROW keys, the cursor will
move continuously within the rows or columns of the LCD screen. (The LCD
Screen is laid out on a Row/Column Grid for navigation)
2 - 6
TEN KEY NUMBER
[1]
[2]
[3]
[1]
[2]
[3]
WINDOW RECALLED
[METER>INPUT1-32]
[METER>BUS/AUX]
[METER>SLOT]
[AUTOMATION>SETUP]
[AUTOMATION>EXECUTE]
[AUTOMATION>EVT EDIT]