Mitsubishi Electric Fresh Master GUF-50RDH4 Operating Instructions Manual page 12

Hide thumbs Also See for Fresh Master GUF-50RDH4:
Table of Contents

Advertisement

O-ring (P20)
1. Rotate the strainer cap counterclockwise and remove it.
3. Replace the strainer cap.
How to remove the humidifying elements
is located on the right side. Swing the rear side of each of the hu-
midifying elements to the right, and take out the humidifying element
bolt.
1. Remove the inner lid.
Inner lid
forward.
2. Holding both ends with your hands, pull the inner lid for-
ward.
2. Remove the water supply tube from the
humidifying element.
Water supply tube
Solenoid valve unit with
pressure regulator
[3]
[2]
[1]
Hose band
remove the water supply tubes. Referring to the procedure en-
titled "removing the humidifying elements" below, remove the
water supply tube at the rear while taking out the front humidi-
fying element.
Strainer
Filter
Strainer cap
O-ring (P22A)
Grip part
[6]
[5]
[4]
Humidifying element
Water supply tube
Caution:
- To remove the water supply tube, hold and slide the hose
bands and remove the water supply tube.
- Do not remove the water supply tube from the solenoid valve
unit with a pressure regulator.
- When removing the water supply tube, be sure that water is
collected on the drain tray inside the main unit.
3. Removing the humidifying elements
side of the humidifying element to the right, lift it upward,
and then pull it out diagonally.
Model name
Quantity
GUF-50RDH4
2
GUF-100RDH4
4
Humidifying element
2. For the third and subsequent humidifying elements, pull the
rod for removal of the humidifying elements forward until
you can reach an element with your hands, and then pull it
out (GUF-100RDH4).
Caution:
- Do not separate the rod for removal of the humidifying ele-
ments from the product.
- Take out the water supply tube together with the humidifying
element. (Collect the residual water in the humidifying ele-
ment using the drain tray.)
- Do not bend or stretch the water supply tubes.
How to wash the humidifying elements
with water
Scrub brush
Fill a bucket or other container with water, then shake each
to wash out any dust and particles.
Caution:
- Do not use a scrub brush to clean the humidifying elements.
- Do not hose off the humidifying elements. Doing do so will
damage them.
clean the humidifying elements.
Humidifying element
Rod for removal of the
humidifying elements
Hose
12

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents