Powering On Your Camcorder - Vivitar 685HD User Manual

NOTE:

Before opening the waterproof casing and putting the device in, carefully check whether
the waterproof ring of the casing is flat and smooth.

After placing the device into the waterproof casing and closing the cover, carefully check
whether the waterproof ring is deformed due to pressure.

After every use in salt water you will need to rinse the outside of the housing with non-salt
water and dry. Not doing this can eventually cause corrosion of the hinge pin and salt
buildup in the seal, which can cause failure.

To clean the seal, rinse in fresh water and shake dry (drying with a cloth may cause lint to
compromise the seal). Re-install the seal into the grooves of the housing.

Powering On Your Camcorder

TURNING POWER ON AND OFF
1. Press and hold the POWER button to turn on the camcorder.
The LCD screen briefly displays 'ON' and opens the default Video Capture Mode.
2. Press the POWER button again to turn the power off.
The LCD screen briefly displays 'OFF' and then powers off.
12