Electrical Connection - Siemens GS..D SERIES Instructions For Use Manual

en
m
Caution
Use only the enclosed hose set or
a hose set purchased from customer
service for connection to the drinking
water mains.
Do not use existing or already used hose
sets.
Connect the appliance to a drinking
water line only:
Minimum pressure: 0.2 Mpa (2 bar)
■
Maximum pressure: 0.8 Mpa (8 bar)
■
Pressure over 0.8 MPa (8 bar): install
■
a pressure limiter between drinking
water connection and hose set
m
Caution
Do not kink, crush, modify or cut through
the water supply hose! Fig. (
Note
The maximum outside diameter
of the water mains (without connecting
pieces) is 25 mm.
m
Caution
After dispensing for the first time, check
that the connections are tight! Fig. )
32

Electrical connection

The socket must be near the appliance
and also freely accessible following
installation of the appliance.
The appliance complies with the
protection class I. Connect the appliance
to 220–240 V/50 Hz alternating current
via a correctly installed socket with
protective conductor. The socket must
be fused with a 10 to 16 A fuse.
For appliances operated in non-
European countries, check whether the
stated voltage and current type match
the values of your mains supply. This
information can be found on the rating
plate. Fig. *
m
Warning
Never connect the appliance
to electronic energy saver plugs.
Our appliances can be used with mains
and sine-controlled inverters. Mains-
controlled inverters are used
for photovoltaic systems which
are connected directly to the national
grid. Sine-controlled inverters must be
used for isolated applications (e.g. on
ships or in mountain lodges) which are
not connected directly to the national
grid.