Stihl MS 150 TC Instruction Manual page 22

English
The Master Control lever moves from
the starting throttle position (n) to the
run position (F) when you press down
the throttle trigger lockout and blip the
throttle trigger at the same time.
To switch off the engine, move the
Master Control lever to Stop (0).
Manual fuel pump
The manual fuel pump bulb must be
pressed:
When starting for the first time.
–
if the fuel tank was run until empty
–
(engine stopped).
20
Holding the Saw
Place your saw on the ground.
N
Make sure you have a firm footing –
check that the chain is not touching
any object or the ground.
Hold the saw firmly with your right
N
hand on the top handle.
Rest your right knee on the
N
carburetor box cover.
Cranking
Pull the starter grip slowly with your
N
right hand until you feel it engage –
and then give it a brisk strong pull
and push down the control handle at
the same time. Do not pull out the
starter rope to full length – it might
otherwise break. Do not let the
starter grip snap back. Guide it
slowly back into the housing so that
the starter rope can rewind properly.
Starting the Saw
WARNING
Bystanders must be well clear of the
general work area of the saw.
Press the manual fuel pump bulb at
N
least nine times – even if the bulb is
already filled with fuel.
MS 150 TC