Table of Contents
Advertisement
Self Diagnostics Failure Gode Explanation
This oven monitors its operalion and displays a Failure Code in the Display Window when a probrem occurs.
What to do when a failure code appears:
-$
l.)
CODE
CAUSE
WHAT TO DO
F01
.Overcooked food
.Temperature
of exhaust air too high.
-Press STOP/RESET Pad
to stop beep.
*Wait for oven to
cool down and reset.
-lf a flame is present,
do not open oven door.
"lf normal
operation does not resume, call the service aoent with
information of failure code.
F33-34
.Defective sensor
circuit
. Unplug lhe oven
and wait more than l0
seconds before reconnecting.
^ lf normal operation
does not resume, call the
service agent with the information of failure
cooe.
F44
'When
a pad was pressed for more
than 30 seconds
.Defective pad
or control circuit
I
z
NOTE: Above codes shown in Display Window do not indicate all the possible lailures on the unit.
Care of Your Microwave Oven
1 . U n p l u g t h e o v e n b e f o r e c l e a n i n g .
2. Keep the inside of the oven clean. When food soatters or
spilled liquids adhere to oven walls, wipe with a damp cloth.
Mild detergent may be used if the oven gets very dirty. The
use of harsh detergent or abrasives is not recommended.
The air intake splash guard/light diffuser can be removed for
cleaning by removing the center plugs from lhe two plastic
rivets. The top is held by two tabs.
Wash in warm dishwater and replace.
3. The outside oven surfaces should be cleaned with a damo
cloth. To prevent damage to the operating parts inside the
oven, water should not be allowed to seep into the ventilation
openrngs.
4 lf the Control Panel becomes wet, clean with a soft, dry cloth.
Do not use harsh detergents or abrasives on Control panel.
When cleaning the Control Panel, leave oven door open to
prevent oven f rom accidentally turning on.
After cleaning, touch STOP/RESET Pad to clear Display
Window.
5. lf steam accumulates inside or around the outside of the oven
door, wipe with a soft cloth. This may occur when the
microwave oven is operated under high humidity conditions
and in no way indicates malfunction of the unit.
6. Clean off grease and dust on bottom surfaces often. Use
warm detergent solution.
7. Cleaning inside the oven outer panel and inside the oven
base should be performed only by qualified service personnel
after taking precautions to drain all stored voltage potential.
The bottom is accessible by removing the center section of
the base and the power and sensor control areas are within
the outer wrap around housing. Avoid using liquids and
cleaning solutions in these areas. Use a dry soft bristle brush
or a cloth. Replace all parts-Do nol connecl the oven to the
electricity supply if any parts are not reassembled.
- 1 8 -
Advertisement
Table of Contents
