Advertisement
Beretto clipper instructions
Cleaning and care
Oil the blade set (Fig. 4).
Do not immerse the appliance in water!
After each use, remove the attachment comb (Fig. 3b)
and use the cleaning brush to remove cut hairs from
the housing opening and from the blade set (Fig. 6).
Remove the blade set to do this (Fig. 5a). The charging
contacts on the appliance and on the charging stand
should always be kept clean.
Only wipe the appliance with a soft cloth, which may
be dampened slightly. Never use solvents or scouring
agents!
The blade set can be cleaned with hygienic spray.
For a long-lasting, good cutting performance, it is
important to oil the blade set frequently (Fig. 4).
Only use Wahl clipper oil.
Clipper oil (3310) and hygienic spray (ZX495) is
available from your dealer or our Service Centre.
If the cutting performance deteriorates after long use
despite regular cleaning and oiling, the blade set
should be replaced.
Use the blade guard when the appliance is not in use.
Always store the appliance with the
blade guard in place.
Changing the blade set
Switch off the appliance using the on/off switch
(Fig. 2b).
The blade set can be removed by sliding it away from
the housing in the direction of the arrow (Fig. 5a).
To replace the blade set, position it with the hook in the
opening of the housing and press it onto the housing
until it clicks into position (Fig. 5b).
8
4
5
a
6
b
Hide quick links:
Advertisement
