Advertisement
Charging the battery
Before the appliance is used for the first time, it should be charged for 3 - 5 hours. It then takes
3 hours to fully recharge the battery again.
The appliance is charged via the charging stand. Place the appliance in the charging stand so
that charging contact is made. During charging, the charging indicator is illuminated. The
charging indicator will begin to blink when almost fully charged and may shut off when fully
charged. Note: If the appliance is fully charged and is placed in the stand to charge, the
charging indicator may not turn on. This does not indicate the appliance can no longer charge, it
means the appliance does not need to draw electricity
because it is already fully charged.
Cutting length adjustment
The cutting length adjustment intergrated in the blade
set (Fig.1) has five settings to determine the length of
the hair from 0.7mm - 3mm. Move the adjusting lever to
the required position and click it into place.
Battery operation
Switch on the appliance using the on/off
switch (Fig. 2a) and, after use, switch it off
again (Fig. 2b). When the battery is fully
charged, the appliance can be used for up
to 90 minutes.
Cutting with attachment combs
Depending on the desired haircut, the appliance can
be operated with or without attachment comb.
The scope of supply includes the following attachment
combs: 3 mm, 6 mm, 9 mm, 12 mm, 18mm
and 25mm cutting length.
Attaching/removing the attachment comb
1. Slide the attachment comb all the way
on to the blade set in the direction
indicated by the arrow. (fig.3a).
2. The attachment comb can easily be
removed by pushing it in the direction
of the arrow. (fig.3b).
Beretto clipper instructions
1
5
2
a
3
1
b
b
a
7
Hide quick links:
Advertisement
