Troubleshooting; Battery Pack And Power - Sony slt-a35 Instruction Manual

Troubleshooting

If you experience trouble with your camera, try the following solutions.
Check the items on pages 179 to 187. Consult your Sony dealer or local
authorized Sony service facility.
Check the following items.
1
Remove the battery pack, and insert the battery pack again after
2
about one minute, and turn on the power.
3 Reset the settings (page 155).
4 Consult your Sony dealer or local authorized Sony service facility.

Battery pack and power

The battery pack cannot be installed.
• As you insert the battery pack, use the tip of the battery pack to push the
lock lever (page 21).
• You can use an NP-FW50 battery pack only. Make sure that the battery is
NP-FW50.
The remaining battery indicator is incorrect, or sufficient remaining
battery indicator is displayed but the power runs out too quickly.
• This phenomenon occurs when you use the camera in an extremely hot or
cold location (page 191).
• The battery pack is discharged. Install a charged battery pack (page 19).
• The battery pack is dead (page 24). Replace it with a new one.
Cannot turn on the camera.
• Install the battery pack correctly (page 21).
• The battery pack is discharged. Install a charged battery pack (page 19).
• The battery pack is dead (page 24). Replace it with a new one.
Downloaded from ManualsCamera.com Manuals
179