Table of Contents
Advertisement
[SETUP] menu
On the menu screen, select [SETUP] from the main menu, and select an item from the sub-menu.
Refer to "Navigating through the menu" (x page 58) for the operation of the menu screen.
f After selecting the item, press asqw to set.
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1)
Press as to select [PROJECTOR ID].
2)
Press the <ENTER> button.
f The [PROJECTOR ID] screen is displayed.
3)
Press as to select [PROJECTOR ID].
[ALL]
[1] - [6]
4)
Press the <ENTER> button.
Note
f The ID number can be set to [ALL], or from [1] to [6].
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computer
control.
If multiple projectors are set up side by side with IDs set to [ALL], they cannot be controlled separately from the projectors with other ID
numbers.
f Refer to "Setting the remote control ID numbers" (x page 56) for how to set the ID number on the remote control.
[PROJECTION METHOD]
Set the projection method in accordance with the installation condition of the projector.
Change the setting if the screen shows horizontally inverted image.
1)
Press as to select [PROJECTION METHOD].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[FRONT]
[REAR]
[VERTICAL FLIP]
Set the display method according to the conditions of use of the projector such as the installation condition and
direction of projection.
Change the setting in such a case when the screen shows vertically flipped image.
1)
Press as to select [VERTICAL FLIP].
2)
Press qw to select an item.
f The items will switch each time you press the button.
[OFF]
[ON]
[SHIFT]
Move the image vertically or horizontally if the image projected is shifted even when the relative position of the
projector and the screen is installed correctly.
70 - ENGLISH
Chapter 4 Settings — [SETUP] menu
Set this item to control without specifying an ID number.
Set this item to specify an individual ID number to be controlled.
Select this item when projecting from the forward of the projection surface.
Select this item when projecting from the backward of the projection surface to forward (in such a way
by using a translucent screen).
The factory default setting.
Select this item when the image is to be projected flipped vertically from the display status set to
[OFF].
Advertisement
Table of Contents
