Removing Sfp Modules - IBM DS4700 Installation, User's, And Maintenance Manual

Protective cap
Figure 34. SFP module and protective cap
3. Remove the protective cap from the SFP port. Save the protective cap for future
4. Insert the SFP module into the host port until it clicks into place. See Figure 35.
Protective cap
Figure 35. Installing an SFP module into the host port
5. Connect an LC-LC fibre-channel cable. For information about the LC-LC cable,

Removing SFP modules

Complete the following steps to remove the SFP module from the host port:
Attention:
you unplug the LC-LC fibre-channel cable before you remove the SFP module.
1. Remove the LC-LC fibre-channel cable from the SFP module. For more
2. Unlock the SFP module latch:
60
IBM System Storage DS4700 Express Storage Subsystem: Installation, User's and Maintenance Guide
Plastic tab
SFP module
use.
Plastic tab
SFP module
see "Using LC-LC fibre-channel cables" on page 61.
To avoid damage to the cable or to the SFP module, make sure that
information, see "Removing an LC-LC fibre-channel cable" on page 64.
v For SFP modules that contain plastic tabs, unlock the SFP module latch by
pulling the plastic tab outward 10°, as shown in Figure 36 on page 61.