Toshiba MMU-AP0091H Owner's Manual page 16

5
ADJUSTMENT OF WIND DIRECTION
High Wall Type
Setup of air direction and swinging
1H series: Refer to description of "2-way Air Discharge Cassette Type".
2H, 3H series: Refer to description of
"4-way Air Discharge Cassette, 1-way Air Discharge Cassette (2SH series), Under Ceiling Type".
Floor Standing Cabinet Type
How to change the air outlet
Change the air outlet in the following procedure.
1
Take off two fixing screws of the air outlet.
(The fixing screws are reused.)
2
Insert the hand into the air outlet and push up it a little,
and then remove the air outlet from the claw hook at rear side.
3
Lift up the air outlet upward and remove it.
4
Reverse the air outlet and attach it to the main unit.
Pay attention so that four claw hooks (two at rear and lower sides each)
are hooked at mounting position.
5
Be sure to tighten the air outlet with the removed fixing screws
so that the air outlet does not come off.
Floor Standing Type
Adjustment of air direction upward/downward
[In Cooling operation]
In cooling operation, move the louver with hands and use it with
horizontal air outlet point so that the cold air diffuses in whole room.
[In Heating operation]
In heating operation, move the louver with hands and use the horizontal louver
with downward set point so that the hot air blows at the foot.
Adjustment of air direction rightward/leftward
[In case of using unsymmetrical air directions]
Lift up the vertical louver lightly, direct it toward the desired direction, and lower it.
In this case, do not use the Swing function.
[In case of automatic swing]
Refer to description of "2-way Air Discharge Cassette,
1-way Air Discharge Cassette Type (1 YH series)".
English-15
2
In this case, do not use the
swing function.
15
1