Connect The Speaker Cables - Panasonic GCSEB E Operating Instructions Manual

Dvd home theater sound system

Hide thumbs

Table of Contents

∫ Front and surround speaker height

(Assembled diagram)

Speaker

You can adjust within this range.

750 mm

1,160 mm

Pipe

818 mm

Base

Attach to lower

rear of speaker.

Adjust the speaker height.

≥Check the screws you tightened on page 4.

e.g. Attaching the stand to the lower rear of the speaker

1 Loosen the attached speaker mounting

plate screw until the attached speaker is

slightly loose and adjustable.

Be careful not to loosen the screw too

much or the speaker may detach and fall.

2 With one hand on the base, and the other

holding the speaker, adjust the height of

the speaker up and down.

≥After adjusting the height, tighten the screw

on the mounting plate securely.

Phillips-head screwdriver

Stopper screw

Screw to stop mounting plate from moving or

sliding below this point.

For your reference

You can enjoy good acoustics by

adjusting the height of the speaker

with the height of the television so the

center positions of both are

approximately the same.

∫ Preventing the speakers from falling over (Front and surround speakers)

Preparation

Attach screw eyes (not included) to secure the speakers to the wall

(‹diagram right).

≥You will need to obtain the appropriate screw eyes to match the

walls and pillars to which the screw eyes are going to be

fastened.

≥Consult with a qualified housing contractor concerning the

appropriate procedure when attaching to a concrete wall or a

surface that may not have strong enough support. Improper

attachment may result in damage to the wall or speakers.

1 Thread the string (not included) through the slot on the

rear of the speaker to prevent it from falling over.

2 Loop the string through the screw eye and tie tightly.

704 mm

Stopper

575 mm

screw

Do not

remove.

Attach to upper

rear of speaker.