Woods MRTA611LDC Instructions Manual page 17

T R
O ELEASE THE
WARNING: Load must be fully supported before releasing vacuum pads.
When the load is at rest and fully supported, pinch the
valve release lever against the valve handle, and push
the valve handle inward to the "RELEASE" position
(power off) until the vacuum pads disengage
completely from the load.
A U
FTER SING THE
Leave the valve handle in the "RELEASE" position (power off).
CAUTION: Do not set the lifter against any surfaces which could soil or damage the
vacuum pads.
Use the hoisting equipment to gently lower the lifter onto a stable support; then detach the
hoisting equipment hook from the lift spool.
If the lifter is transported to another location, use the original shipping crate and secure the lifter
so as to protect the vacuum pads and all other components from damage while in transit.
Storing the Lifter
Use the covers supplied to keep the vacuum pads clean.
In accordance with CE Standard EN 13155, the lifter is designed to rest on relatively
horizontal surfaces without tipping over. To store the lifter in this way, set the lifter
with the pads facing downward on a clean, smooth, flat surface. Then lower the lift bar to a
horizontal orientation and place a support under the lift spool.
Charge the battery completely when placing it in storage and at six-month intervals thereafter
(see MAINTENANCE: B
connectors uniting the battery to the battery charger and to the vacuum generating system, in
order to minimize power drainage. Preferred temperatures for storing the battery are 32° to 70°
Fahrenheit [0° to 21° Celsius]. Higher temperatures require the battery to be charged more
frequently. Storage at temperatures above 100° Fahrenheit [38° Celsius] should be avoided.
Rev 3.0/10-06
P
ADS FROM THE
L
IFTER
R ). After charging the battery, disconnect the electrical
ATTERY ECHARGE
QUADRA-TILT ROTATOR • DC-VOLTAGE
L
OAD
TO RELEASE
Page 16