Operating Environment - Woods MRTA611LDC Instructions Manual

Conversely, allowable thickness increases as load weight decreases. In addition, an operator
may be able to manually counteract the tendency of unstable loads to tilt out of the upright
position, provided that the operator maintains control of the load at all times (see
OPERATION: T
O
necessary, contact Wood's Powr-Grip for help in determining the maximum thickness
permitted when handling any specific load.
Note: Vacuum pads can stain or deform load surfaces with light colors or soft coatings. The
operator should test such surfaces for detrimental effects before using the lifter on them.
O
PERATING
The operator must determine whether the lifter is intended to be used in each work environment,
in accordance with the following restrictions:
WARNING: Never use lifter in dangerous environments.
• This lifter is not intended for use in any environment that is inherently dangerous to the
operator or likely to compromise the lifter's ability to function. Environments containing
explosives, caustic chemicals and other dangerous substances must be avoided when using
the lifter.
• The lifter's work environment is limited by the Operating Elevation and Operating Temperatures
indicated in SPECIFICATIONS.
• Using the lifter in wet environments may require the operator to take special precautions:
Moisture on contact surfaces of the load or vacuum pads diminishes the lifter's slip resistance,
thereby reducing the lifting capacity (see MAINTENANCE: V
Coefficient).
WARNING: Moisture reduces slip resistance of vacuum pads.
Although the lifter's exterior surfaces can tolerate some exposure to water vapor, they are not
designed to be water-tight. Submerging the lifter or using it in rain may damage lifter
components; these and similar conditions must be avoided.
Rev 3.0/10-06
L M L
IFT AND OVE THE OAD
E
NVIRONMENT
QUADRA-TILT ROTATOR • DC-VOLTAGE
: About the Tilt Linkage and T T
O ILT THE
P M
ACUUM AD AINTENANCE
L ). If
OAD
: Friction
Page 9