Rear View - Panasonic WJ-FS316 Operating Instructions Manual

Rear View

<WJ-FS309/FS409>
9
IN
OUT
9
<WJ-FS316/FS416>
16
IN
OUT
16
q Video Input Connectors (VIDEO IN)
These connectors accept a composite video signal
from a camera.
Note: If the input signals have a high jitter content, as in
the case of a VCR playback picture, it may not be
possible to synchronize this unit.
w Video Output Connectors (VIDEO OUT)
The video signals connected to the Video Input
Connectors (VIDEO IN) are looped through to these
connectors with an automatic 75
e Alarm/Remote Control Connector (ALARM/
REMOTE)
This connector accepts the alarm signals from the
associated alarm sensor units and the control signals
from the external system.
r Playback Input Connector (PLAY IN)
The playback signal from the time lapse VCR is sup-
plied to this connector.
t Record Output Connector (REC OUT)
The recording signal for the time lapse VCR is provided
via this connector.
8
8 7 6 5 4 3 2
8 7 6 5 4 3 2
VIDEO
15 14 13 12 11 10 9
15 14 13 12 11 10 9
termination.
1
1
8 7 6 5 4 3 2
8 7 6 5 4 3 2
VIDEO
y Multiscreen Output Connector (MULTISCREEN OUT)
The video output signal for the multiscreen monitor is
provided via this connector.
u Spot Output Connector (SPOT OUT)
Provides the video output signal for the spot monitor.
i Data Port (DATA)
For exchange control data with the WV-CU360 System
Control Unit or a PC within a system.
o Camera Switching Input Connector
(CAMERA SW IN)
The camera switching pulse from the time lapse VCR is
supplied to this connector.
The camera switching interval (Sequential Dwell Time)
can be synchronized with the time lapse mode set in
the associated time lapse VCR.
!0 Signal Ground Terminal (SIGNAL GND)
!1 Power Cord
i o !0
SIGNAL
GND
CAMERA
ALARM/REMOTE
DATA
SW IN
MULTI
PLAY IN REC OUT SCREEN OUT SPOT OUT
u !1
i o !0
1
SIGNAL
GND
CAMERA
ALARM/REMOTE DATA
SW IN
1
MULTI
PLAY IN REC OUT SCREEN OUT SPOT OUT
u !1