Panasonic BL-WV10 Getting Started page 25

Error Message
The timer could not be set
because the recording
time overlaps with another
timer. Set a different start
and/or end time. (ED7)
To use the sensor, first
enter the Administrator
user name and password
on this camera's [User
Info] screen. (ED8)
No camera name entered.
(ED9)
The IP address and port
are not set. (EE1)
There was a recording
error. (EE2)
This camera is used for
Sensor Alert mode.
Set Sensor Alert to [-] on
the [Camera Sensors]
screen. (EE3)
Set [Sensor Alert] to [-].
(EE4)
This sensor is used for
sensor recording.
Turn off the record
program. (EE5)
Causes and Solutions
This error is displayed if the recording time overlaps
with another timer recording program.
• Reset using different specifications for the
recording.
This error is displayed if the user name and password
required for sensor use for remote cameras are
different than those of the administrator.
• Enter the administrator name and password
in the [User Info] screen.
This error is displayed when the name is not set for a
newly registered remote camera.
• Enter a camera name.
This error is displayed when the IP address and port
number are not set for a newly registered remote
camera.
• Enter a camera address.
This error is displayed if for some reason, during
standard recording, the signal from a camera is lost.
• Make sure camera monitoring is possible,
then try recording again.
This error is displayed when you attempt to erase a
camera that has been set for Sensor Alert.
• Turn off the camera's sensor in the [Camera
Sensors] section of the [Sensor Alert] screen.
This error is displayed when you attempt to disable a
remote camera's sensor when that camera has been
set for Sensor Alert.
• Turn off the camera's sensor in the [Camera
Sensors] section of the [Sensor Alert] screen.
This error is displayed when you attempt to disable a
remote camera's sensor when that camera has been
set for timer recording using continuous sensor
recording.
• Deselect the camera chosen for continuous
sensor recording or re-do the settings with a
different camera.
Getting Started
25